CHAPTER 7 16-BIT TIMER/EVENT COUNTERS 0 AND 1
User’s Manual U15905EJ2V1UD
226
(4) Compare operation
The TMn register has two capture/compare registers. These are the CCn0 register and the CCn1 register. A
capture operation or a compare operation is performed according to the settings of both the CMSn1 and
CMSn0 bits of the TMCn1 register. If the CMSn1 and CMSn0 bits of the TMCn1 register are set to 1, the
register operates as a compare register.
A compare operation that compares the value that was set in the compare register and the TMn register count
value is performed.
If the TMn register count value matches the value of the compare register, which had been set in advance, a
match signal is sent to the output controller. The match signal causes the timer output pin (TOn) to change
and an interrupt request signal (INTCCnn) to be generated at the same time.
If the CCn0 or CCn1 registers are set to 0000H, the 0000H after the TMn register counts up from FFFFH to
0000H is judged as a match. In this case, the TMn register value is cleared (0) at the next count timing,
however, this 0000H is not judged as a match. Also, the 0000H when the TMn register begins counting is not
judged as a match.
If match clearing is enabled (CCLRn bit = 1) for the CCn0 register, the TMn register is cleared when a match
with the TMn register occurs during a compare operation.
Remark
n = 0, 1
Figure 7-6. Compare Operation Example (When CCLR1 = 1 and CC10 Is Other Than 0000H)
0001H
0000H
n
1
TM1
Compare register
(CC10)
Match detection
(INTCC10)
Remarks 1. A match is detected immediately after the count-up, and the match detection signal is generated.
2. n
≠ 0000H
相关PDF资料
XF2L-0535-1 CONN FPC 5POS 0.5MM SMT
PIC18LF23K22-I/SS IC PIC MCU 8KB FLASH 28SSOP
PIC16LF1933-I/ML IC PIC MCU FLASH 4K 28-QFN
PIC16F1933-I/ML IC MCU 8BIT FLASH 28-QFN
PIC16F785-I/ML IC PIC MCU FLASH 2KX14 20QFN
XF2L-0425-1 CONN FPC 4POS 0.5MM SMT
PIC16F1933-I/MV IC MCU 8BIT FLASH 28-UQFN
PIC16F785-I/SO IC PIC MCU FLASH 2KX14 20SOIC
相关代理商/技术参数
PIC24F08KL302-I/SP 功能描述:16位微控制器 - MCU 8KB FLASH 1KB RAM 256B 3V RoHS:否 制造商:Texas Instruments 核心:RISC 处理器系列:MSP430FR572x 数据总线宽度:16 bit 最大时钟频率:24 MHz 程序存储器大小:8 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:2 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:VQFN-40 安装风格:SMD/SMT
PIC24F08KL302-I/SS 功能描述:16位微控制器 - MCU 8KB FLASH 1KB RAM 512B 3V 10-BIT ADC RoHS:否 制造商:Texas Instruments 核心:RISC 处理器系列:MSP430FR572x 数据总线宽度:16 bit 最大时钟频率:24 MHz 程序存储器大小:8 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:2 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:VQFN-40 安装风格:SMD/SMT
PIC24F08KL302T-I/ML 功能描述:16位微控制器 - MCU 8KB FLASH 1KB RAM 512B 3V 10-BIT ADC RoHS:否 制造商:Texas Instruments 核心:RISC 处理器系列:MSP430FR572x 数据总线宽度:16 bit 最大时钟频率:24 MHz 程序存储器大小:8 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:2 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:VQFN-40 安装风格:SMD/SMT
PIC24F08KL302T-I/MQ 功能描述:16位微控制器 - MCU 8KB FL 1KB RAM 256B 3V RoHS:否 制造商:Texas Instruments 核心:RISC 处理器系列:MSP430FR572x 数据总线宽度:16 bit 最大时钟频率:24 MHz 程序存储器大小:8 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:2 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:VQFN-40 安装风格:SMD/SMT
PIC24F08KL302T-I/SO 功能描述:16位微控制器 - MCU 8KB FLASH 1KB RAM 512B 3V 10-BIT ADC RoHS:否 制造商:Texas Instruments 核心:RISC 处理器系列:MSP430FR572x 数据总线宽度:16 bit 最大时钟频率:24 MHz 程序存储器大小:8 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:2 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:VQFN-40 安装风格:SMD/SMT
PIC24F08KL302T-I/SS 功能描述:16位微控制器 - MCU 8KB FLASH 1KB RAM 512B 3V 10-BIT ADC RoHS:否 制造商:Texas Instruments 核心:RISC 处理器系列:MSP430FR572x 数据总线宽度:16 bit 最大时钟频率:24 MHz 程序存储器大小:8 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:2 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:VQFN-40 安装风格:SMD/SMT
PIC24F08KL401 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:Low-Power, Low-Cost, General Purpose 16-Bit Flash Microcontrollers with nanoWatt XLP Technology
PIC24F08KL401-I/MQ 功能描述:16位微控制器 - MCU 8KB FLASH 1KB RAM 512B 3V 10-BIT ADC RoHS:否 制造商:Texas Instruments 核心:RISC 处理器系列:MSP430FR572x 数据总线宽度:16 bit 最大时钟频率:24 MHz 程序存储器大小:8 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:2 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:VQFN-40 安装风格:SMD/SMT